Die Struck Gold Pins Without Enamel, With Sandblast Background.

Stamp hard mold making die struck pins.

The professonal tips for the custom die struck lapel pins.

1. Hard mold need to be hard enamel, all die struck pins need the engraved hard mold. which should be baked under high temperature after the mold engraved.

2. For smal size pins, if the order quantity is big, it is better to use more big hard mold to engrave the pin, than normal size hard mold material. That can be more hard than small mold, and can avoid the broken beasuse small hard mold very easy to be stamped broken during the course of die struck.

3. About the metal lines of the die struck metal pins, if there are some small parts need to be filled color, that is better to use cooper material which can be more easy die struck out the pins. The logo on the hard mold is revert, so the small raised metal on the hard mold easy to be damaged.

Normally for the die struck lapel pins, the clients most time ask for the 3D surface looking.

To make good looking 3D die struck lapel pins, the designer is the most important. Because the come out pins, will be exactly the same with the 3D design artwork. So before that, please check carefully about the 3D design.

Another tips for the die struck pins with many cuts.

For the lapel pins with many cut through holes, that will be very complex, for the factory to produce the pins with many holes cut. To make it more easy, we normally use the zinc alloy material to instead the iron or copper material to make the cut holes lapel pins.

So when you get the die struck lapel pins produced by zinc alloy material, that is special process.